SKU: 601850
SEACHEM PHOS GUARD 100ML
in stock
In Stock
Out of Stock
Temporarily Out of Stock
Discontinued
Special Order
Price: $6.59
Product Details
Seachem PhosGuard 100ml
PhosGuarda rapidly removes phosphate and silicate from marine and freshwater aquaria. It is not recommended for phosphate buffered freshwater. PhosGuarda is highly porous for high capacity and bead-shaped for optimum water flow. It outperforms all competing products. 500 mL easily treats over 150 gallons*. This product is sold by volume. Cited weight is minimal weight. DIRECTIONS: Use one bag for each 120 L (30 US gallons). For best results, PhosGuarda should be placed so as to maximize the flow of water through it. It may be used in a canister filter, box filter, or any high flow area of a trickle filter. Leave product in place for 4 days, then test phosphate or silicate concentrations with either MultiTest: Phosphatea or MultiTest: Silicatea. If the concentration of the component you are trying to decrease has not dropped to around 0.02 mg/L, then replace the PhosGuarda, otherwise leave in place until levels begin to climb again. As long as concentrations remain under control, the product is not exhausted. PhosGuarda does not leach phosphate or silicate back into the water and may be removed, dried, and returned to service until exhausted. Each 100 mL of PhosGuarda will remove up to 20 mg/L phosphate in 120 L (30 US gallons) of water, depending on the initial phosphate/silicate concentrations and the current biological load. Over treating is not recommended. PhosGuarda is not an exchange resin, it does not release anything into the water. Continuous use of small quantities is better than intermittent use of larger quantities. Caution! May generate heat on initial contact with water. Pre-wet by adding to a double volume of freshwater (e.g. 250 mL of product in 500 mL water), followed by a rinse.
i100 mL bagged (Treats 120 L (30 US Gallons))
PhosGuarda rapidly removes phosphate and silicate from marine and freshwater aquaria. It is not recommended for phosphate buffered freshwater. PhosGuarda is highly porous for high capacity and bead-shaped for optimum water flow. It outperforms all competing products. 500 mL easily treats over 150 gallons*. This product is sold by volume. Cited weight is minimal weight. DIRECTIONS: Use one bag for each 120 L (30 US gallons). For best results, PhosGuarda should be placed so as to maximize the flow of water through it. It may be used in a canister filter, box filter, or any high flow area of a trickle filter. Leave product in place for 4 days, then test phosphate or silicate concentrations with either MultiTest: Phosphatea or MultiTest: Silicatea. If the concentration of the component you are trying to decrease has not dropped to around 0.02 mg/L, then replace the PhosGuarda, otherwise leave in place until levels begin to climb again. As long as concentrations remain under control, the product is not exhausted. PhosGuarda does not leach phosphate or silicate back into the water and may be removed, dried, and returned to service until exhausted. Each 100 mL of PhosGuarda will remove up to 20 mg/L phosphate in 120 L (30 US gallons) of water, depending on the initial phosphate/silicate concentrations and the current biological load. Over treating is not recommended. PhosGuarda is not an exchange resin, it does not release anything into the water. Continuous use of small quantities is better than intermittent use of larger quantities. Caution! May generate heat on initial contact with water. Pre-wet by adding to a double volume of freshwater (e.g. 250 mL of product in 500 mL water), followed by a rinse.
i100 mL bagged (Treats 120 L (30 US Gallons))
| Product PDF: | |
|---|---|
| Extra Details: |
